Supervisor Functions Terminal User Guide
74
Supervisor Sub-menus
There are two Supervisor sub-menus. They are the Password
menu and the Config menu. They allow access to extended
options within the Supervisor menus.
To access the Password menu press the menu key twice, then
choose SUPERVISOR by pressing the F3 key. You will be asked
to type your current supervisor password, and confirm this by
pressing the enter key, and choose PASSWORD by pressing the
F2 key.
MENU, MENU, F3, [password], ENTER, F2
Below is a summary of the functions within the Password menu
and how to access them, and what they do.
Some Supervisor functions must only be used when
instructed to do so by the terminal Helpdesk.
Deletes all datasets for one or all acquirers
from the terminals memory. Do not use this
feature unless instructed to do so by the
terminal Helpdesk.
Allows the Message Authentication Code
(MAC) key to be reset to the initial value for
one or all acquirers. Do not use this feature
unless instructed to do so by the terminal
Helpdesk.
Allows the secure password used for
communications to the TMS to be reset to the
initial value. Do not use this feature unless
instructed to do so by the terminal Helpdesk.
Allows the Supervisor password (and/or
Refund password) to be changed. The new
password must be used for all future
password requests.
To Next Page
Loading...
Need help?
General
