Ingenico iCT220 User Manual

Terminal User Guide Supervisor Functions
75
To access the Config menu press the menu key twice, then
choose SUPERVISOR by pressing the F3 key. You will be asked
to type your current supervisor password, and confirm this by
pressing the enter key, and choose CONFIG by pressing the F3
key.
 MENU, MENU, F3, [password], ENTER, F3
Below is a summary of the functions within the Config menu
and how to access them, and what they do.


Some Supervisor functions must only be used when
instructed to do so by the terminal Helpdesk.
First Config Menu
PRINT EMV
Prints EMV data loaded on the terminal. Do
not use this feature unless instructed to do
so by the terminal Helpdesk.
PRINT CERTS
Prints Certificates loaded on the terminal. Do
not use this feature unless instructed to do
so by the terminal Helpdesk.
SET PSTN
Allows the telephone network (PSTN) prefix
number to be set. For further information
refer to the section entitled Telephone
Lines and Broadband.
SCAN NETWRK
Prints a rolling data sheet of the mobile
network. Do not use this feature unless
instructed to do so by the terminal Helpdesk.
Second Config Menu (Press menu once)
SELECT N/W
Allow the selection of a different mobile
network. Do not use this feature unless
instructed to do so by the terminal Helpdesk.

Ingenico iCT220 Specifications

General

Weight	325 g
Display	128 x 64 pixels
Connectivity	Ethernet
Card Readers	Magnetic stripe
Security	PCI PTS 3.x certified
Processor	ARM9 32-bit RISC processor