Ingersoll-Rand INSIGHTqc - Page 82

Job Name
Indicates the name given for the
user defined job.
Pset Name
Indicates the name given for the
user defined Pset.
Barcode
If enabled, it displays barcode
scanned from a scanner.
Operator Name
Indicates the name of the operator
who performed the fastening.
Job ID
Matched with a job and is used for
external job selection.
Step ID Matched with a step.
Job Cycle Number
Incremental number of jobs run by
the controller. This is used to
uniquely identify the fastening
results associated with the
execution of a particular job.
Plausibility Check
Indicates whether or not current
plausibility was enabled for the
fastening that generated the
fastening results.
Plausibility High Pass
Indicates whether or not the
current plausibility check against
the current plausibility high limit
passed or failed.
Plausibility Low Pass
Indicates whether or not the
current plausibility check against
the current plausibility low limit
passed or failed.
Gradient
Detects serious fluctuations in the
coefficient of friction in rotating
joint components during a
tightening cycle.
Dual Slope
Indicates whether or not dual
slope checks were enabled for the
fastening that generated the
fastening results.