Advanced Management Feature Support (RMM4) Intel® Server Board S1200V3RP TPS
Revision 1.2
the firewall and, in case of a private internal network, the NAT (Network Address Translation)
settings have to be configured accordingly.
7.1.2 Performance
The remote display accurately represents the local display. The feature adapts to changes to
the video resolution of the local display and continues to work smoothly when the system
transitions from graphics to text or vice versa. The responsiveness may be slightly delayed
depending on the bandwidth and latency of the network.
Enabling KVM and/or media encryption will degrade performance. Enabling video compression
provides the fastest response while disabling compression provides better video quality.
For the best possible KVM performance, a 2Mb/sec link or higher is recommended.
The redirection of KVM over IP is performed in parallel with the local KVM without affecting the
local KVM operation.
7.1.3 Security
The KVM redirection feature supports multiple encryption algorithms, including RC4 and AES.
The actual algorithm that is used is negotiated with the client based on the client’s capabilities.
7.1.4 Availability
The remote KVM session is available even when the server is powered-off (in stand-by mode).
No re-start of the remote KVM session is required during a server reset or power on/off. A BMC
reset (for example, due to a BMC Watchdog initiated reset or BMC reset after BMC FW update)
requires the session to be re-established.
KVM sessions persist across system reset, but not across an AC power loss.
7.1.5 Usage
As the server is powered up, the remote KVM session displays the complete BIOS boot process.
The user can interact with BIOS setup, change and save settings as well as enter and interact
with option ROM configuration screens.
At least two concurrent remote KVM sessions are supported. It is possible for at least two
different users to connect to the same server and start remote KVM sessions.
7.1.6 Force-enter BIOS Setup
KVM redirection can present an option to force-enter BIOS Setup. This enables the system to
enter F2 setup while booting which is often missed by the time the remote console redirects the
video.
7.2 Media Redirection
The embedded web server provides a Java applet to enable remote media redirection. This may
be used in conjunction with the remote KVM feature, or as a standalone applet.
The media redirection feature is intended to allow system administrators or users to mount a
remote IDE or USB CD-ROM, floppy drive, or a USB flash disk as a remote device to the server.
To Next Page
Loading...
Need help?
General
