100 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
If set to No, the input needs both states to toggle between set and unset (pulse
key switch).
4.1.n.6.16 Key set
The Key set option defines the zone as a key switch for area set. The following
options are available:
• Off: the area set is not affected by the zone.
• Key part set: zone is a key switch for area part set.
• Key full set: zone is a key switch for area full set.
4.1.n.6.17 Key unset
If the Key unset option is set to Yes, the zone is a key switch that unsets an area.
4.1.n.6.18 Technical full set
If the Technical full set option is set to No, the technical alarms in this zone are
disabled when the area is fully set.
4.1.n.6.19 Technical unset
If the Technical unset option is set to No, the technical alarms in this zone are
disabled when the area is unset.
4.1.n.6.20 Technical part set
If the Technical part set option is set to No, the technical alarms in this zone are
disabled when the area is partially set.
4.1.n.6.21 Keypad LCD
If the Keypad LCD option is set to Yes, when the zone activates, the zone name
is displayed on the keypad LCD on all keypads, related to the area.
To Next Page
Loading...
Need help?
General
