108 Advisor Advanced ATSx000A(-IP) Installation and Programming Manual
Fobs
4.2 RF fobs
This menu lets you see all programmed fobs, select an existing fob, or create a
new one.
Fob options
4.2.0 Add fob
To add a fob, follow one of the procedures described in “Wireless device
programming” on page 197.
4.2.n Select fob
Select an existing fob to program.
4.2.n.1 Fob name
Use the Fob name option to set a fob name. The fob name identifies the fob to
the end-user for alarm reporting or for display of status or error message.
When a fob is created, it is given the default name “Fob Ex.y”, where <x> is the
expander number, and <y> is an expander input number. For example, default
fob name “Fob E2.8” is given to the fob assigned to input 8 on the expander 2.
A fob name can consist of 16 characters.
4.2.n.2 Assigned user
Assign an existing user to the selected fob.
Note: One user can have a few fobs assigned. However, one fob can be
assigned only to one user.
4.2.n.3 Buttons
Use the Buttons menu to assign an appropriate function to a button or a button
combination.
Table 29 on page 109 lists buttons and combinations that are available.
To Next Page
Loading...
Need help?
General
