Advisor Advanced ATSx000A(-IP) Installation and Programming Manual 167
9.1.n.8.2.1 Suppress FTC
If the Suppress FTC option is set to Yes, no FTC fault is activated for this central
station when the voice protocol is used.
9.1.n.8.2.2 Without ACK
If the Without ACK option is set to Yes, a recipient of a voice message does not
need to acknowledge the message.
Otherwise, he must acknowledge it by pressing a phone key using tone dialing
mode. The panel tries to retransmit the message until it is acknowledged.
9.1.n.9 OP/CL report
9 OP/CL report
>Separate<
The OP/CL report option defines if opening and closing is reported for all areas
with the same account code, or for each of those. The following options are
available:
• Combined: When all areas with the same account code are armed, a closing
is reported using the area and user who armed it. An opening is reported only
when the first of the areas with the same account code is disarmed.
• Separate: For any of areas with the same account code a closing and an
opening is reported. The area modifier indicates the area concerned (see
“9.1.n.8.1.1 Area modifier” on page 166).
Note: When (X)SIA protocol is selected, separate reporting works only when SIA
area modifier is enabled.
See “9.1.n.5 Accounts” on page 164 for more details.
9.1.n.10 Delete CS
To remove a central station, select a central station using the cursor, or by
entering the central station number, and go to the Delete central station menu.
The display shows:
Choose Ok and press Enter. This removes the central station.
Repeat the command to delete other central stations, or press Clear to exit and
return to the higher menu level.
Note: You cannot delete a central station unless your user group authorizes you
to do so.
To Next Page
Loading...
Need help?
General
