Aim the remote control at the IR receiver located at the front of the unit to test
operation.
To connect the remote control to the DVR:
1. Press the Menu button on the front panel or right-click the mouse and select
the Menu button. The main menu window appears.
2. Click Display Mode Settings > Monitor.
3. Check the device address value. The default value is 255. This device
address is valid for all IR controls.
Note: The DVR will respond to any remote control that has an address
between 1 and 255.
4. On the remote control press the Device button.
5. Enter the device address value. It must be the same as that on the DVR.
6. Press the OK button on the remote control.
To place batteries into the IR remote control:
1. Remove the battery cover.
2. Insert the batteries. Make sure that the positive (+) and negative (−) poles are
correctly placed.
3. Replace the battery cover.
Troubleshooting the remote control:
If the IR remote control is not functioning properly, perform the following tests:
• Check the battery polarity.
• Check the remaining charge in the batteries.
• Check that the IR remote control sensor is not masked.
If the problem still exists, please contact your administrator.
To Next Page
Loading...
Need help?
General
