Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 101
Chapter 7—Commands
UG – Graphics Information Inquiry
Description This command will cause the printer to send information about
graphics currently stored in the printer back to the host.
Syntax UG
Remarks The printer will send the number of graphics and the name of
each graphic to the host through the RS-232 or USB port.
The UG command will be executed directly, without appending
any Linefeed.
Example UG :Returns number of graphics and
all graphic names, for example:
UG001
LOGO
To Next Page
Loading...
Need help?
General