Intermec EasyCoder C4 - Two-Dimensional Bar Codes, General Part

40 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 7—Commands
b – Two-Dimensional Bar Codes, General Part
Description This command is used to print two of three complex bar codes;
Datamatrix, PDF 417, and MaxiCode. The command consists of
two parts; a leading set of general positioning and bar type select
parameters, and a trailing code-specifi c part defi ning the bar
code’s appearance and its input data.
Syntax bp
1
,p
2
,p
3
,[code specifi c options]
Parameters p
1
Horizontal start position (X) in dots.
p
2
Vertical start position (Y) in dots.
p
3
Code type:
D Selects Datamatrix (option, requires special fi rmware).
M Selects MaxiCode.
P Selects PDF417.
[code specifi c options], see the following two pages.
Remarks The standard program packages contains MaxiCode, PDF 417,
and Datamatrix.
If the amount of data will not fi t in the area specifi ed, the
indicator will light orange, indicating an error.