110 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 7—Commands
W – Windows Mode
Description This command is used to enable/disable the Windows command
mode (special applications only).
Syntax Wp
1
Parameters p
1
Windows Mode enable/disable:
Y Enables Windows Mode.
N Disables Windows Mode (default).
Remarks When enabled, the printer will accept Windows mode escape
sequences to print data. When disabled, escape sequences will be
ignored up to the next linefeed.
The Windows mode escape sequences are only used by the
Windows Printer Driver. When working with a main frame or
other non-Windows host, this mode can be disabled to prevent
erratic operation.
Examples WY↵ :Enables Windows Mode
WN↵ :Disables Windows Mode
To Next Page
Loading...
