Intermec EasyCoder C4 Reference Manual

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 93
Chapter 7—Commands
q – Set Label Width
Description This command is used to set the label width when using less than
full width labels.
Syntax qp
1
Parameters p
1
Width of label measured in dots.
Default:
832 at 203.2 dpi (8 dots/mm)
1204 at 300 dpi (11.81 dots mm)
Remarks The q command will cause the image buffer (see M command)
to be formatted to match the label width, that is width is traded
off for increased length within the same memory size.
The q command will also automatically set the margins
according to the following rule:
(No. of dots on printhead - label width in dots)/2 (center-aligned)
Note: If an R command (Reference Point) is sent after a q
command, the image buffer will be automatically reformatted to
match the width of the printhead and the margins will be reset
accordingly.
Example q416↵ :Sets label width to 416 dots

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English