20 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 5—Editing in Form Edit Mode
Example
Assuming that...
• the printer has been set up for the application (see page 14),
• the length of the label and the gap has been determined by printing a
Test Label (see page 2),
• and the graphic (that is the Intermec logotype) used in the example
has been downloaded to the printer as described on page 68 (GM
command)
1
,
...we will now edit a label that can be saved as a form in the printer's
memory and retrieved when so required. It also means that we can use
counters and variables.
When we are fi nished, the label will look like this:
1
/. The Intermec logotype is not included in the software package and
is only included in the example to demonstrate how to print a graphics
fi eld. You can substitute it with any graphics of approximately the same
size. If you fi nd it diffi cult to download graphics, you could omit the GG
command from the example until you have become more familiar with
the concept.
To Next Page
Loading...
Need help?
General