88 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 7—Commands
PA – Print Automatic
Description This command is used in a stored form sequence to automatically
print the form as soon as all variable data has been supplied.
Syntax PAp
1
[,p
2
]
Parameters p
1
Numbers of label sets (1-65535).
p
2
Number of copies of each label (1-65535). Used in combination with counters
to print multiple copies of the same label.
Remarks Refer to the P command for explanations on how to print
multiple labels with counters. The PA command follows the same
principles.
The PA command can only be used with forms containing at
least one variable (see V command). If there is no variable in
the form, the printer will enter a loop and print continuously!
Examples FK"TEST6"↵ :Deletes form “TEST6”
FS"TEST6"↵ :Starts form store sequence
V00,50,N,"Enter text"↵ :Defines variable
A24,24,0,4,1,1,N,V00↵ :Writes text with variable
PA1↵ :Prints 1 label automatically
FE↵ :Ends form store sequence
FR"TEST6"↵ :Retrieves form “TEST6”
?↵ :Gets variables
This is variable text :Data for variable 00
To Next Page
Loading...
Need help?
General