Intermec EasyCoder C4 - UP Code Page & Memory InquiryPrint

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 105
Chapter 7—Commands
UP – Code Page & Memory Inquiry/Print
Description This command will cause the printer to print and send the
currently selected code page and memory status to the host
through the RS-232 or USB port.
Syntax UP
The printer will:
• Send information on the currently selected code page and
memory status back to the host (same as UM command).
• Print the current printer confi guration (same as U command).
The format of the data sent to the host is as follows:
UM p
1
,p
2
,p
3
,p
4
,p
5
,p
6
,p
7
,UI p
8
,p
9
,p
10
Parameters p
1
Image buff er size in kilobytes.
p
2
Form memory allocation size in kilobytes.
p
3
Form memory free in kilobytes.
p
4
Graphic memory allocation size in kilobytes.
p
5
Graphic memory free in kilobytes.
p
6
External font memory allocation size in kilobytes.
p
7
External font memory free in kilobytes.
p
8
Number of data bits.
p
9
Code page.
p
10
Country code.
Example UP↵ :Returns memory status and current code page
and prints configuration on label.
Also see I, M,U,UI, and UM commands.