Intermec EasyCoder C4 Reference Manual

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 59
Chapter 7—Commands
f – Cut Position
Description This command is used to adjust the cutting position along the
Y-axis in relation to the media according to characteristics of
individual printers and batches of media.
Syntax fp
1
Parameters p
1
Cut position index measured in dots:
203.2 dpi (8 dots/mm):
Recommended: 070–130.
Min/max: 020–180 (lower or higher values ignored).
Default: 100
300 dpi (11.81 dots/mm):
Recommended: 050–150.
Min/max: 000–200 (lower or higher values ignored).
Default: 100
Remarks When using labels on liner, the printer will advance each printed
label to the cutting position (between two labels) according to
the program before the liner is cut. Due to differences between
batches of media, the printer may not cut exactly between labels,
but either cut a slice at the last part of the printed label or a slice
at the front part of next label.
Cutting through labels should be avoided, because the adhesive
will stick to the cutting parts and prevent them from operating
properly.
If the cut occurs in the already printed label, increase the cut
position index value.
If the cut occurs in the next label, decrease the cut index value.
Example f110↵ :Increases the cut position index value.

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English