Intermec EasyCoder C4 - N Clear Image Buffer

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 83
Chapter 7—Commands
N – Clear Image Buff er
Description This command is used to clear the image buffer before building
a new image. It also clears any error list that not yet has been
presented.
Syntax N
Remarks The N command is essential when printing labels in the Direct
Mode. It is not necessary to use an N command before printing
a form. An N command must not be used inside a form in the
Form Edit Mode.
Example N↵ :Clears image buffer