Intermec EasyCoder C4 - Z Print Direction

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 113
Chapter 7—Commands
Z – Print Direction
Description This command is used to select the print orientation.
Syntax Zp
1
Parameters p
1
Print orientation:
T Start printing from the top of image buff er (default).
B Start printing from the bottom of image buff er.
Remarks This command affects the complete print image, including text,
bar codes, graphics, lines, and boxes, as well as the location of the
reference point (see R command).
Note that printing a test label in the Test Mode, or by means of
a U or UP command, will reset the print direction to default (=
ZT).
ZT Command:
ZB Command:
Example ZB↵ :Starts printing from the bottom of the image buffer.
EASYCODER C4
Feed Direction
EASYCODER C4
Feed Direction