Intermec EasyCoder C4 Reference Manual

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 73
Chapter 7—Commands
JB – Disable Top of Form Backup
Description This command disables automatic top of form backup of the
media.
Syntax JB
Remarks Top of form backup is used in connection with the j command,
which makes the printer feed out an extra amount of media after
printing the label, so as to allow the media to be torn or peeled
off properly. It does not work with a cutter.
By default, the media is pulled back before printing the fi rst label
in next batch as to allow the printing to start at the top of the
label, see JF command.
The JB command will disable this function, that is any j com-
mand will be ignored, and the printer will stop feeding when
the end of the label becomes aligned with the printhead’s dot
line. However, the j command is kept stored in memory and can
be enabled again using a JF command. To disabled top of form
baclup with a cutter, fi rst send an O command followed by a JB
command.
Example JB↵ :Disables top of form backup

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English