48 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 7—Commands
C – Cut Immediate
Description This command is used to make the cutter perform a cutting cycle
without printing a form.
Syntax C
Remarks The command C is used for two purposes. C appended by
parameters is used to defi ne counters in the Form Edit mode,
whereas C without any appending parameters is used to initiate a
cutting operation.
C (Cut Immediate) can not be used inside a form or in
connection with a keyboard/display unit (KDU).
To perform self-cleaning of the cutter blade, issue fi ve consecutive
C commands without any media loaded.
Example C↵ :Performs a cutting cycle
To Next Page
Loading...
