Intermec EasyCoder C4 - Page 98

92 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 7—Commands
Q – Set Form Length (Black Mark), cont.
Examples On this tag, the black marks are printed on the perforation in a
203.2 dpi (8 dots/mm) printer:
p
1
= 31.0 mm (248 dots)
p
2
= 7.0 mm (56 dots)
p
3
= 0.5 mm (4 dots)
The Q command would be: Q248,B56+4↵
On the tag below, the black marks are printed between the
perforations. The printer has a 203.2 dpi (8 dots/mm) printhead.
p
1
= 31.0 mm (248 dots)
p
2
= 7.0 mm (56 dots)
p
3
= 17 mm (136 dots)
The Q command would be: Q248,B56-136 ↵
p
3
p
2
p
1
Perforation
p
3
p
2
p
1
Perforation