Intermec EasyCoder C4 Reference Manual

22 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 5—Editing in Form Edit Mode
Draw a Box and two Lines
Start to draw the surrounding box using the X command and then draw
the two lines using the LO command.
Command Explanation
X0,0,4,752,584↵
Draw a box
LO0,144,752,4↵
Draw a black line
LO440,232,4,160↵
Draw a black line
Place a Text Line with Fixed Data
Enter a 90° rotated text line containing the fi xed data "Made in Sweden"
in text size 1. The quotation marks enclosing the fi xed data will not be
printed. The text size (1) is the smallest resident font in the printer.
Command Explanation
A40,400,1,1,1,1,N,"Made in Sweden"↵
90 degree. text line, fi xed data
Place a Variable Text
The next line is a text line, using text size 5 in reverse and prints the
variable V00. The data printed in this fi eld must be sent to the printer at
the time of form retrieval.
Command Explanation
A24,160,0,5,1,1,R,V00 ↵
Write a text line, 1:st variable
Place a Combination of Fixed Data and a Variable
The following two command lines consist of a combination of fi xed data
enclosed in quotation marks and variable data.
Command Explanation
A24,250,0,4,1,1,N,"MODEL: "V01↵
Text line, fi xed data + 2:nd variable
A472,312,0,4,1,1,N,"Checked by: "V02↵
Text line, fi xed data + 3:rd variable

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English