EasyManuals Logo

Intermec EasyCoder C4 Reference Manual

Intermec EasyCoder C4
152 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
46 Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual
Chapter 7—Commands
If the start value entered, when the form is retrieved for printing,
is started by one or several zeros (0), the entire area specifi ed by
p
2
(number of digits) will be padded with leading zeros, that is p
3
(fi eld justifi cation) will have no effect.
Note: If a single counter is stepped up several times on the same
form, then the step value p4 must be set to the number of times
the counter is used in the form or equivalent to what the step
values for the single counter add up to in this form. A Cn±x
command must also be used when designing the actual form. See
the A and B commands.
Example This form lets you test fi eld justifi cations by entering various
start values when the form is retrieved for printing. Test various
number of digits, with and without leading zeros.
FK"TEST5"
FS"TEST5"
C0,5,L,+1,"Start value CNT 0"
C1,5,R,+1,"Start value CNT 1"
C2,5,C,+1,"Start value CNT 2"
C3,5,N,+1,"Start value CNT 3"
A50,50,0,3,1,1,N,"Cnt left justified:"
A50,100,0,3,1,1,N,"Cnt right justified:"
A50,150,0,3,1,1,N,"Cnt center justified:"
A50,200,0,3,1,1,N,"Cnt not justified: "
FE

Table of Contents

Other manuals for Intermec EasyCoder C4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec EasyCoder C4 and is the answer not in the manual?

Intermec EasyCoder C4 Specifications

General IconGeneral
BrandIntermec
ModelEasyCoder C4
CategoryPrinter
LanguageEnglish

Related product manuals