Intermec EasyCoder C4 Reference Manual

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 81
Chapter 7—Commands
M – Memory Allocation, cont.
Memory Cartridges
The printers can be fi tted with a memory cartridge containing an
additional 256K of SRAM and/or 1 MB fl ash memory.
256K SRAM Cartridge
Expands image buffer by 392K to a total of 648K.
1 MB Flash Cartridge
Expands form, graphics, and external font memory areas by 1MB
to a total of 1.2MB.
Checking the Memory Allocation
The amount of memory and the current allocation can be
printed on a label using the U command, or by printing a test
label in the Dump Mode, see page 2.
When to Re-allocate the Memory
• If you need to change the size of the forms memory to
accommodate more or less forms.
• If you need to change the size of the graphics memory to
accommodate more or less graphics.
Image Buffer
The image buffer is the area where the active print image is
temporarily stored. Calculate if you need to expand the image
memory with an SRAM memory cartridge by measuring the
largest full width form intended to be printed (take future needs
into consideration).
For less than full width labels, also refer to the q command,
which allows trading off print width for increased label length
with the same image buffer size.

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English