Intermec EasyCoder C4 Reference Manual

Intermec EasyCoder ESim v4.00—Programmer’s Reference Manual 85
Chapter 7—Commands
O – Options Select, cont.
The following table illustrates the results of some combinations
of the various O command parameters:
Command LTS (N) DT/TTR
Mode (D)
Reverse
Gap (S)
Cutter (C)
O Enable TT Mode Disable Disable
OD Enable DT Mode Disable Disable
OS Enable TT Mode Enable Disable
OD,S Enable DT Mode Enable Disable
OS,Cnnn|b Enable TT Mode Enable Enable
OD,S,Cnnn|b Enable DT Mode Enable Enable
ON Disable TT Mode Disable Disable
ON,D Disable DT Mode Disable Disable
ON,D,S Disable DT Mode Enable Disable
ON, Cnnn|b Disable TT Mode Disable Enable
OCnnn|b not used TT Mode Disable Enable
OD,Cnnn|b Disabled DT Mode Disable Enable
Example ON,D↵ :Enable DT Mode
:Disable LTS
:Disable reverse gap sensor
:Disable cutter

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English