Intermec EasyCoder C4 - D - Density Command Settings; Direct Thermal Printing

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 113 113
Appendix 1
Direct Thermal Printing
Label/Tag Type Ribbon Type Rec. Density at Speed S = 2 Max. Speed
Duratherm II – D10 S3
Duratherm II Tag – D9 S1
Duratherm Lightning – D9 S3
Duratherm IR – D7 S3
Thermal Top – D8 S3
Thermal Eco – D8 S3
Thermal Top Board – D11 S2
Thermal Eco Board – D7 S2
Thermal IR – D12 S3
Thermal Top High Speed – D6 S3
D - Density Command Settings
Recommended density settings are identifi ed in the following tables.
Further adjustments might be necessary depending on print speed,
bar code density, orientation, and ambient temperature/humidity
conditions.