Intermec EasyCoder C4 Programmer's Guide

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 72
Chapter 7 Commands
Description This command allows the advanced programmer to substitute the Euro currency
character (€) for any ASCII character in printer-resident fonts 1-5. The original
character can be restored by sending the oR command.
Syntax oR[p
1
[,p
2
]]
Parameters p
1
If p1 = E, the Euro character will be mapped to the code page position
specifi ed by p
2
.
If no p
1
or p
2
parameters are given, all code pages will be reset to original
default character mapping.
p
2
Specifi es the code page position for the Euro character in the range ASCII
32-255 decimal for all code pages, provided p
1
= E.
If p2 is omitted, the Euro character will be mapped to the code page position
ASCII 213 decimal for all code pages, provided p
1
= E.
Remarks The oR command is a global printer command.
• It cannot be issued inside a form.
• It must be issued prior to issuing a text command and printing it.
• It affects a single character on all code pages. Changing the character position
will restore the original character.
• Flash memory printer parameter data are preserved until they are changed by
the oR command or the printer is reset to default.
Examples oRE ↵ :Places the Euro character in position ASCII 213 dec.
oRE,128 ↵ :Places the Euro character in position ASCII 128 dec.
oR ↵ :Clears character substitution and
restores default character maps
oR – Character Substitution

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English