Intermec EasyCoder C4 - Enable PromptsCode; UI Enable PromptsCode Page Inquiry

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 86
Chapter 7 Commands
Description This command will cause the printer to enable prompts to be sent to the host
and to send the currently selected code page to the host through the serial
RS-232 port.
Syntax UI
The printer will send information on the currently selected code page back to
the host in the following format:
UIp
1
p
2
,p
3
Parameters p
1
Number of data bits.
p
2
Code page.
p
3
Country code.
Remarks The KDU (Keyboard Display Unit) automatically sends this command each
time power is applied. The UI command is disabled by removing power from
the printer for 60 seconds.
Example UI ↵ :Enables prompts from host
and returns current code page, for example
UI80,001
Also see I and U commands
UI – Enable Prompts/Code Page Inquiry