Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 73
Chapter 7 Commands
Description
This command is used to print the contents of the image buffer.
Syntax
Pp
1
[,p
2
]
Parameters p
1
Numbers of label sets (1-65535).
p
2
Number of copies of each label (1-65535). Used in combination with counters
to print multiple copies of the same label.
Remarks
Important!
The P command cannot be used inside a stored form sequence. For automatic
printing of stored forms, use the PA command.
Examples
P ↵ :Prints one label set
P1 ↵ :Prints one label set
P2,1 ↵ :Prints two label sets of one label each
P5,2 ↵ :Prints fi ve label sets of two labels each
The principles for how counters are printed is illustrated by this example,
where the print command is P2,2:
P – Print
Counter: 1
Label No. 1
Counter: 1
Label No. 2
Counter: 2
Label No. 3
Counter: 2
Label No. 4