Intermec EasyCoder C4 - LW Line Draw White

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 65
Chapter 7 Commands
Description This command is used to draw white lines, effectively erasing previous infor-
mation.
Syntax LWp
1
,p
2
,p
3
,p
4
Parameters p
1
Horizontal start position (X) in dots.
p
2
Vertical start position (Y) in dots.
p
3
Horizontal length in dots.
p
4
Vertical length in dots.
Example N ↵ :Clears image buffer
LO50,100,400,20 ↵ :Draws black line A
LO50,200,400,20 ↵ :Draws black line B
LO50,300,400,20 ↵ :Draws black line C
LW200,50,20,400 ↵ :Draws white line D
P1 ↵ :Prints one label
Line A
Line B
Line C
Line D
(dotted border not
printed in reality)
LW – Line Draw White