Intermec EasyCoder C4 Programmer's Guide

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 13
Chapter 3 Setting Up the Printer
Command Explanation
↵ CR/LF to start command structure
D8 ↵ Set density
j110 ↵ Set media feed adjustment for peel-off operation
Let us assume that we will use an EasyCoder C4 for direct thermal
printing. We will print full width Thermal Top labels in the
peel-off mode without using the label taken sensor. The default
communication setup and character set are acceptable.
Thus, a few setup parameters should be changed in the Direct
Mode:
• Density from 10 to 8
• Media feed adjustment from 136 to 110
Enter the following commands:
Example

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English