Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 85
Chapter 7 Commands
Description
This command will cause the printer to send information about graphics currently
stored in the printer back to the host.
Syntax
UG
Remarks
The printer will send the number of graphics and the name of each graphic to the
host through the serial RS-232 port.
The UG command will be executed directly, without appending any Linefeed.
Example
UG :Returns number of graphics and all graphic names, for example:
UG001
LOGO
UG – Graphics Information Inquiry
To Next Page
Loading...
Need help?
General