Intermec EasyCoder C4 - Windows Mode

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 94
Chapter 7 Commands
Description This command is used to enable/disable the Windows command mode (special
applications only).
Syntax Wp
1
Parameters p
1
Windows Mode enable/disable:
Y Enables Windows Mode.
N Disables Windows Mode (default).
Remarks When enabled, the printer will accept Windows mode escape sequences to print
data. When disabled, escape sequences will be ignored.
The Windows mode escape sequences are only used by the Windows Printer Driver.
When working with a main frame or other non-Windows host, this mode can be
disabled to prevent erratic operation.
Examples WY ↵ :Enables Windows Mode
WN ↵ :Disables Windows Mode
W – Windows Mode