Intermec EasyCoder C4 - Speed Select

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 81
Chapter 7 Commands
S – Speed Select
Description This command is used to select the label speed while printing.
Syntax Sp
1
Parameters p
1
Speed select value:
0 30 mm/sec. (1.2 inches/sec.)
1 40 mm/sec. (1.6 inches/sec.)
2 50 mm/sec. (2 inches/sec.)
3 75 mm/sec. (3 inches/sec.)
Remarks Changing the print speed will affect the blackness of the printout, which may have
to be adjusted by means of a D command.
Example S2 ↵ :Sets the print speed to 50 mm/sec. (2 inches/sec.).