Intermec EasyCoder C4 - JB Disable Top of Form Backup

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 59
Chapter 7 Commands
Description This command disables automatic top of form backup of the media.
Syntax JB
Remarks Top of form backup is used in connection with the j command, which makes the
printer feed out an extra amount of media after printing the label, so as to allow the
media to be torn off or peeled off properly.
By default, the media is pulled back before printing the fi rst label in next batch as to
allow the printing to start at the top of the label, see JF command.
The JB command will disable this function, that is any j command will be ignored,
and the printer will stop feeding when the end of the label becomes aligned with the
printhead’s dot line. However, the j command is kept stored in memory and can be
enabled again using a JF command.
Example JB ↵ :Disables top of form backup
JB – Disable Top of Form Backup