Intermec EasyCoder C4 Programmer's Guide

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 60
Chapter 7 Commands
Description This command enables automatic top of form backup of the media.
Syntax JF
Remarks Top of form backup is used in connection with the j command, which makes the
printer feed out an extra amount of media after printing the label, as to allow the
media to be torn off or peeled off properly.
By default, top of form is enabled, that is the media is pulled back before
printing the fi rst label in next batch as to allow the printing to start at the
top of the label.
Top of form backup can be disabled by a JB command, that is any j command will
be ignored, and the printer will stop feeding when the end of the label becomes
aligned with the printhead’s dot line. However, the j command is kept stored in
memory and can be enabled again using a JF command.
Example JF ↵ :Enables top of form backup
JF – Enable Top of Form Backup

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English