Intermec EasyCoder C4 - Page 79

Intermec EasyCoder C4 – Programmer’s Guide Ed. 3 78
Chapter 7 Commands
Examples
On this tag, the black marks are printed on the perforation:
p
1
= 31.0 mm (248 dots)
p
2
= 7.0 mm (56 dots)
p
3
= 0.5 mm (4 dots)
The Q command would be: Q248,B56+4 ↵
On the tag below, the black marks are printed between the perforations:
p
1
= 31.0 mm (248 dots)
p
2
= 7.0 mm (56 dots)
p
3
= 17 mm (136 dots)
The Q command would be: Q248,B56-136 ↵
Q – Set Form Length (Black Mark), cont.
p
3
p
2
p
1
Perforation
p
3
p
2
p
1
Perforation