Intermec EasyCoder PF4i Service Manual

86 Intermec EasyCoder PF2i, PF4i, and PF4i Compact Industrial—Service Manual
Chapter 7—Print Mechanism
IPL only
The sensitivity of the LSS is confi gured at startup. To force adjustment of
the sensitivity (corresponding to a TESTFEED in Fingerprint), raise and
close the printhead and then press the Feed/Pause key.
Adjustment of the LSS Lateral Position
The LSS can be moved laterally between 5 fi xed positions. The two parts
of the LSS must be set individually to the same position. Push them
inwards as far as they go and then pull them out—one at the time—while
counting the clicks from the snap-locks. Use a straight-slot screwdriver or a
similar tool.
In EasyCoder PF4i and PF4i Compact Industrial, the lower part of the
LSS may be diffi cult to adjust laterally. However, there is a hole in the
bottom plate (marked “ADJ”) through which the LSS can be reached.
The fi xed detection points of the sensor in relation to the inner edge of the
media are:
One click out 3 mm .118 inches
Two clicks out 8 mm .315 inches
Three clicks out 12 mm .472 inches
Four clicks out 16 mm .639 inches
Five clicks out 20 mm .787 inches
When using irregularly shaped labels, align the LSS with the front tips of
the labels.

Intermec EasyCoder PF4i Specifications

General

Print technology	Direct thermal
Maximum resolution	203 x 203 DPI
Standard interfaces	RS-232, USB 2.0
Internal memory	16 MB
Power consumption (standby)	15 W
Power consumption (printing)	300 W
Media thickness	3/7.5 mm
Maximum label width	104 mm
Maximum label length	0.4 m
Maximum roll diameter	152.4 /213 mm
Maximum internal memory	1 GB
Supported network protocols	TCP/IP, LPR/LPD, FTP, BOOTP, DHCP, HTTP, SNMPv3, SMTP, SNMP-MIB II
Product color	Blue, Silver
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	40 - 104 °F
Operating relative humidity (H-H)	20 - 80 %

Weight and Dimensions

Depth	405 mm
Width	244 mm
Height	178 mm
Weight	8000 g