of the inverter
Factory barcode
1
6000H Range: 0000~FFFF W
Factory barcode
2
6001H Range: 0000~FFFF W
Factory barcode
3
6002H Range: 0000~FFFF W
Factory barcode
4
6003H Range: 0000~FFFF W
Factory barcode
5
6004H Range: 0000~FFFF W
Factory barcode
6
6005H Range: 0000~FFFF W
R/W characteristics means the function is with read and write characteristics. For example,
“communication control command” is writing chrematistics and control the inverter with
writing command (06H). R characteristic can only read other than write and W characteristic
can only write other than read.
Note: when operate on the inverter with the table above, it is necessary to enable some
parameters. For example, the operation of running and stopping, it is necessary to set
P00.01 to communication running command channel and set P00.02 to MODBUS
communication channel. And when operate on “PID reference”, it is necessary to set P09.00
to “MODBUS communication setting”.
The encoding rules for device codes (corresponds to identifying code 2103H of the inverter)
Code high
8bit
Meaning
Code low 8
position
Meaning
01 Vector inverter
02 Special for water supply
03 intermediate frequency 1500HZ
00 CHV
04 intermediate frequency 3000HZ
01 GD100 Vector inverter 01 CHE
02 GD 100 intermediate frequency 1500HZ
To Next Page
Loading...
