Goodrive270 series VFD for fan and pump Basic operation guidelines
-107-
S1
S2
S3
S4
HD1A
P05.08 (input terminal polarity)
P05.01
P05.02
P05.03
P05.04
T delay
T delay
T delay
T delay
T delay
P05.13
P05.15
P05.17
P05.19
P05.21
0
1
2
3
4
5
.
.
.
.
29
30
P05.09 (digital filter time)
(Default value is 1)
(Default value is 4)
(Default value is 7)
(Default value is 0)
(Default value is 0)
P05.00
(HDI input type)
0
1
0
1
-1
0
1
-1
0
1
-1
0
1
-1
0
1
-1
P17.12
Digital input
terminal state
P07.39
Input terminal
state of present
fault
Fault?
Fault
Run
Digital function selection
T delay
T delay
T delay
T delay
T delay
P05.12
P05.14
P05.16
P05.18
P05.20
P05.05
This parameter is used to set the corresponding function of digital multi-function input terminals.
Note: Two different multifunction input terminals cannot be configured with a same function.
The VFD does not act even if there is signal input. Set
unused terminals to "no function” to avoid misaction.
External terminals are used to control the forward/reverse
running of the VFD.
Three-wire running control
The terminal is used to determine the three-wire running
control of the VFD. For details, see the description for
P05.13.
For details about frequency of jogging running and
ACC/DEC time of jogging running, see the description for
P08.06, P08.07, and P08.08.
The VFD blocks output, and the stop process of motor is
uncontrolled by the VFD. This mode is applied in the
scenarios with large-inertia loads and without stop time
requirements.
Its definition is the same as P01.08, and it is mainly used in
remote control.
External fault reset function, same as the reset function of
the STOP/RST key on the keypad. You can use this
function to reset faults remotely.
The VFD decelerates to stop, however, all the run
parameters are in memory state, such as PLC and PID
parameters. After this signal disappears, the VFD will revert
to the state before stop.
When external fault signal is transmitted to the VFD, the
To Next Page
Loading...
Need help?
General
