Goodrive270 series VFD for fan and pump Function parameter list
-158-
Stop speed
detection time
Terminal-based
running command
protection at
power-on
When the channel of running commands is
terminal control, the system detects the state of
the running terminal during power-on.
0: The terminal running command is invalid at
power-on. Even the running command is
considered as valid during power-on, the VFD
does not run and it keeps the protection state
until the running command is canceled and
enabled again.
1: The terminal running command is valid at
power-on. If the running command is considered
as valid during power-on, the VFD is started
automatically after the initialization.
Note: Exercise caution before using this
function. Otherwise, serious result may follow.
Action selected
when running
frequency less than
frequency lower
limit (valid when
frequency lower
limit greater than 0)
The function code determines the running state
of the VFD when the set frequency is lower than
the lower-limit one.
0: Run at the frequency lower limit
1: Stop
2: Sleep
The VFD coasts to stop when the set frequency
is lower than the lower-limit one. If the set
frequency exceeds the lower limit one again and
it lasts for the time set by P01.20, the VFD
resumes the running state automatically.
Used to set the wake-up-from-sleep delay time.
When the running frequency of the VFD is lower
than the lower limit, the VFD becomes standby.
When the set frequency exceeds the lower limit
one again and it lasts for the time set by P01.20,
the VFD runs automatically.
To Next Page
Loading...
Need help?
General
