35
Chapter 3: Troubleshooting & Testing
FlexJet is not responding. Please check your cables and baud rate.
The Control Center did not get a response from a FlexJet on the COM port
it is currently congured to use. If the FlexJet is connected and the power is
on, click ‘Yes’. Follow the directions in the FlexJet User Guide for conguring
the COM port and baud rate.
NOTICE: Your rmware is out of date. It is recommended that you
update it as soon as possible, but it is not required. This program will
work with new and old rmware. Firmware upgrades are available
from Ioline Customer Service at (425) 398-8282 PST-USA.
The rmware in the FlexJet is obsolete. An upgrade is highly recommended.
Contact Ioline Customer Service to obtain the software and instructions.
The identication numbers for this board have already been set. You
must use the ‘Reset Machine ID’ dialog to change them now.
The user is attempting to overwrite an internal license that is already set. Contact
Ioline customer service for assistance.
To Next Page
Loading...
