IP-COM Pro-6-IW - Page 74

Version V1.0
67
II. Configure the switch
Create IEEE 802.1Q VLANs described in the following table on the switch.
Port Connected To
Accessible VLAN ID
Port Type
PVID
AP
1,2,3,4
Trunk
1
LAN server
3,4
Trunk
1
Router
2,4
Trunk
1
Retain the default settings of other ports. For details, refer to the user guide for the switch.
III. Configure the router and internal server
To ensure a normal internet access for wireless clients connected to the AP, the router and
internal server must support the QVLAN function and need to be configured. See the
following table.
Router:
Port Connected To
Accessible VLAN ID
Port Type
PVID
Switch
2,4
Trunk
1
Internal server:
Port Connected To
Accessible VLAN ID
Port Type
PVID
Switch
3,4
Trunk
1
For details, refer to the user guides for the corresponding devices.
---End
Verification
Wireless clients connected to the internet wireless network can only access the internet,
wireless clients connected to the oa wireless network can only access the LAN. Wireless
clients connected to the vip wireless network can access both the internet and LAN.