iPECS UCM
Installation Manual Issue 1.1
26
Be sure to follow these precautions when wiring:
Do not wire the telephone cable in parallel with an AC power source, computer, fax machine, etc.
If the cables are run near such wires, shield the cables with metal tubing or use shielded cables and
ground the shields.
If the cables are run on the floor, use protectors to prevent the wires from being damaged by foot
traffic. Avoid wiring under carpets.
Do not use the same power supply outlet for computers, fax machine, and other office equipment to
avoid inducing RF noise into the iPECS UCM system.
The power and battery switches must be OFF during wiring. After wiring is completed, the power
switch may be turned ON.
If an extension does not operate properly, disconnect the telephone from the extension line and then
re-connect, or turn the System power OFF and then ON again.
Use unshielded twisted pair cable for connecting CO lines and stations.
3.2 Unpacking
Check to see that each iPECS UCM carton includes the following items:
UCM-MGC3
UCM-1URMC
UCM-S2K
To Next Page
Loading...
