isobus VT50 - Page 31

VT50 – Operation
5.3.4.3 Select Lighting Mode
To select a lighting mode proceed as follows:
1. Press on the "Lighting mode" button on the touchscreen or turn the scroll
wheel until the button is highlighted in white and then press on the scroll
wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
 A selection list opens.
2. Select the desired setting from the list. To do so, press the button with the
lighting mode.
3. Confirm your selection by pressing "OK" or pressing the button with the
lighting mode again or by pressing the scroll wheel.
5.3.4.3.1 Enter Lighting threshold
An on/off point is specified for the display lighting. The value provided by the
brightness sensor is the reference variable.
The illumination is activated when exceeding the ON activation point and
deactivated when undershooting the OFF activation point.
Proceed as follows to enter the lighting threshold:
1. Press on the "Lighting Threshold" button on the touchscreen or turn the scroll
wheel until the button is highlighted in white and then press on the scroll
wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
2. Enter the value on the touchscreen using the digit field or the slider.
3. Confirm your entry with "OK".
Note
The value for the Display lighting is given as a percentage and can be adjusted in
steps of 10%.
30