CCI.Cam – Operation
4.4.1 Enter time interval
To enter the time interval for the automatic camera switching, proceed as follows:
1. Press on the "Time interval" button on the touchscreen or turn the scroll wheel
until the designator is highlighted in white and then press on the scroll wheel.
Once the button is highlighted you can, alternatively, also press the "OK" (F6)
button.
2. Enter the new value for the time interval on the touchscreen using the digit field
or the slider.
3. Confirm your entry with "OK".
Note
Values between 1 and 10 seconds are valid for the time interval value range.
4.4.2 Reset all settings
To reset all settings for the time interval, proceed as follows:
1. Press the "Reset" button (F1) on the touchscreen.
The settings are immediately reset to factory settings, there is no warning
message.
Note
The factory setting for the time interval is 2 seconds.
14
To Next Page
Loading...