138
2 cm (3/4˝)
2 cm (3/4˝)
0.3 cm
Left of teeth
Raise the foot and replace it with CONCEAL® zipper
foot Z*.
Remove the basting stitches.
Open the zipper and insert the pull tab between fabric
and zipper tape to allow the slider to reach the stopper.
(12) Pull tab
Right side of tape
Turn and fold the bodice to the left.
Seam along the edge of the right zipper tape and reverse
the stitches 2 cm (3/4˝) before the zipper bottom.
Left side of tape
Raise the foot and close the zipper.
Replace the foot with zipper foot E.
Turn and fold the bodice to the right. Seam along the
edge of the left zipper tape and reverse the stitches 2 cm
(3/4˝) before the zipper bottom.
Raise the zipper teeth on the left and lower the foot so
the right groove of the foot catches the zipper teeth.
Stitch through the zipper tape and fabric up to the end of
the opening. Reverse the stitches to secure the seam.
(13) Zipper teeth
(14) Right groove
Slide up the stopper to 0.3 cm (1/8˝) below the end of the
opening and fasten the stopper with pliers.
(15)
Stopper
(12)(12)
(13)
(14)
(15)
To Next Page
Loading...
