26
5.
Slowly release the needle threader lever to its original
position to pass the thread through the needle eye.
3.
Pull the thread up and slip it between the thread
cutter and face plate from behind.
Pull the thread toward you to cut.
4.
Pull down the needle threader lever as far as it will
go.
Built-in Needle Threader
1.
3.
4.
5.
(1)
(4)
(2)
2.
(3)
NOTE:
Be sure that the thread pass the slit of the needle
threader as shown.
(4) Slit
NOTE:
• The needle threader can be used with a #11 to #16
needle.
• Thread size 50 to 90 is recommended.
• Do not use thread size 30 or thicker.
• The needle threader cannot be used with the twin
needle.
1.
Press the needle up/down button to raise the needle.
Press the lockout key to lock the machine.
(1) Needle up/down button
(2) Lockout key
2.
Pull the thread up to the left, over the needle threader
guide while holding the thread near the spool with
your hand.
(3) Needle threader guide
NOTE:
If the thread loop is formed after releasing the needle
threader lever, pull out the thread loop through the
needle eye.
To Next Page
Loading...
