69
B13 Darning
1.
Attach automatic buttonhole foot R and pull the
button holder all the way out.
Place the fabric under the foot, and lower the needle
at the starting point. Then lower the foot.
(1) Button holder
(2) Starting point
2.
Start the machine and continue sewing until the
machine stops automatically. When nished sewing,
a conrmation message will appear.
To adjust the evenness of darning stitches
You can correct unevenness of darning stitches by
turning the stitch width adjusting dial or pressing the “–”
or “+” key of the adjusting window.
If the left corner is lower than the right side, turn the stitch
width adjusting dial counterclockwise or press the “–” key
to correct it.
If the right corner is lower than the left side, turn the stitch
width adjusting dial clockwise or press the “+” key to
correct it.
NOTE:
The machine will sew the darning at maximum 2 cm
(3/4˝) length and xed 0.9 cm (3/8˝) width when
sewing until it stops automatically.
To sew shorter darning
Sew the rst line to the desired length and stop the
machine.
Press the reverse button and start the machine again.
The machine will sew the rest of the darning and stop
automatically.
(4) Reverse button
(5) Required length
To sew the same size darning
When nished sewing, a conrmation message will
appear.
Simply start the machine to sew another layer of darning
stitches in the same size.
To sew the next layer of darning stitches in a different
size, press the X key.
(3)
1.
2.
3.
(1)
(2)
0.9 cm
(3) 2 cm (3/4˝)
3.
Sew another layer of darning over the rst layer, at a
right angle to it.
(4)
(5)
To Next Page
Loading...
