Janome HORIZON Memory Craft 9480 QC PROFESSIONAL - Programming a Pattern Combination; Mirror Image of Patterns

85
PROGRAMMING A PATTERN
COMBINATION
The patterns in the decorative stitch category and
monograms can be programmed to make a pattern
combination.
You can program up to 100 patterns in each combination
by pressing the program key.
The images of programmed patterns are shown on the
left side of the visual touch screen.
(1) Program key
Mirror Image of Patterns
To sew or program the pattern as a mirror image, press
the vertical mirror image key or horizontal mirror image
key.
Select the desired patterns to create the mirror image.
Press the vertical or horizontal mirror image key again to
cancel the mirror image function.
(2) Vertical mirror image key
(3) Horizontal mirror image key
NOTE:
• Horizontal mirror image is available only for specic
patterns. For pattern identication, these patterns
are colored in blue on the reference chart inside the
top cover.
• The vertical or horizontal mirror image key will gray
out when the selected pattern is not suitable for the
mirror image.
NOTE:
Presser foot pressure cannot be adjusted to the stitch
patterns of a pattern combination individually.
If you attempt to do so, only the last pattern’s
presser foot pressure settings are applied to all the
programmed patterns.
(1) (6)(2) (3)
(4)
To view the entire pattern combination, press the cursor
keys to scroll over the pattern combination or press the
preview key to show the entire pattern combination at a
glance.
Press the function switch key to show the preview key.
(4) Cursor keys
(5) Preview key
(6) Function switch key
(5)